BSW Wood Shaft - Northern Pine PREMIUM - Ø 11/32"
Pinewood is one of the oldest used woods - at least for the construction of arrows because already in the stone age shafts were made of it.
And even today, pine shafts are a popular and proven basis for home-made arrows.
The pine owes its popularity to its balanced ratio of stability and weight and its good characteristics: it has a very even grain, is very robust and heavier than cedar and spruce shafts. They are also easy to work with, stain, prime or varnish.
Each shaft is unique
Since wood is a natural product, each shaft is unique. Apart from the standard turned diameter, the shafts differ in their appearance and characteristics.
The grain or appearance (annual rings, flames) is various for each shaft. Also the spin value is always individual and cannot be determined exactly, therefore the shafts are only sorted into categories with a spin width of 5 lbs. In order to have as even shafts as possible, all shafts are handspined, checked for cracks, reflex tested and aligned.
Premium quality wood shafts have special characteristics that influence their stability, durability and, of course, the flight characteristics of the later arrow. They are specially selected and have a significantly less "restlessness" in the grain on the outside. The annual rings run more evenly over a longer distance, the escaping flames are rarer.
"Extra spine shafts" and "Weighing out shafts".
With the two services "Weigh out shafts" and "Extra spine shafts", you can reduce the differences in characteristics between the shafts.
- In the "weigh out shafts" service, you can define the tolerance range of the weight deviation within the ordered quantity of shafts and minimize it to up to 5 grains.
- The "Extra spine shafts" service also gives you the option of defining the tolerance range for the spine and limiting it to a maximum of 1 lb.
Shaft diameter: 11/32 "
Length: 24-32" (selectable)
If you opt for the extra service "Weigh out shaft" and "Extra spins", please note that the shafts can only be shortened and varnished after weighing & spinning. As wood is a natural product, there may be variations after shortening due to the uneven nature of the wood.